Adaptec 2020ZCR Reference Guide - Page 48
container create mvolume
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
container Commands container create mvolume To create a multilevel volume set, use the container create mvolume command. You can create the following types of multilevel volume sets: I Volume set of stripe sets I Volume set of mirror sets I Volume set of RAID 5 arrays I Volume set of volume sets Notes When creating a multilevel array of volume sets on a NetWare server, you specify the container IDs (as described in the Parameters section) for the arrays from which you want to create the multilevel volume set. If NetWare is using any of these arrays, an appropriate message displays. This message indicates that one or more of the arrays you specified is in use by NetWare. The message directs you to remove any NetWare volumes and partitions from these arrays. You can then create a multilevel array of volume sets on a NetWare server. After you create a multilevel volume set you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create mvolume [/label{=string}] {container} [{container}...] Parameters {container} Specifies the ID number (0 to 63) of the array from which you want to create the multilevel volume set. 3-17