Adaptec 2020ZCR Reference Guide - Page 72
container assign drive_letter, container extend mvolume
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
container Commands Parameters {container} Specifies the ID number (0 to 63) of the array whose file system you want to extend. Examples Typically, you would use the container extend file_system command after adding a level to an array and, perhaps, after extending a multilevel volume set. Before extending a file system, use the container list command to obtain information about any existing arrays: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size E: 0 Volume 300MB NTFS 63 Volume 100MB 1:00:0 64.0KB: 100MB 62 Volume 100MB 1:01:0 64.0KB: 100MB 61 Volume 100MB 1:02:0 64.0KB: 100MB The following list describes the sequence that caused the previous example to display: 1 Create a volume set of 100 MB on disk (1,0,0) with the container create volume command. 2 Add a level to the volume set created in Step 1 with the container add_level command. 3 Assign a drive letter to the volume set created in Step 1 with the container assign drive_letter command. 4 Create an NTFS file system on the volume set created in Step 1 with the container format command. 5 Create a second volume set of 100 MB on disk (1,1,0) with the container create volume command. 6 Create a third volume set of 100 MB on disk (1,2,0) with the container create volume command. 7 Use the container extend mvolume command to add the arrays created in Steps 5 and 6 to the array created in Step 1. 3-41