Adaptec 2020ZCR Reference Guide - Page 42

container Commands The following list describes the change to the display as the result of creating a multilevel array of mirror sets with the container create mmirror command: I The Dr column is blank to indicate that the newly created mirror sets (63 and 62) do not have a drive letter assigned to them. I The Type column displays Mirror for arrays 63 and 62 to indicate that the underlying arrays are mirror sets. I The State column displays the state of the arrays, which in this example are all in the Normal state. Note that this column appears only if you specify the /full switch with the container list command. I The Scsi C:ID:L column displays the SCSI device ID for the disk(s) on which the underlying mirror set(s) reside. In the example, mirror set 63 resides on disk 0:02:0 and 0:04:0. Mirror set 62 resides on disk 0:03:0 and 0:05:0. I The Partition Offset:Size column displays the partition offset(s) and size(s) for the underlying mirror set(s). In the example mirror set 63 and 62 have partition offsets of 64.0 KB and sizes of 15.0 MB. If a partition is dead, the ":" (colon) in the Partition Offset:Size column changes to a "!" (exclamation point). See the disk remove dead_partitions (page 5-10) command for more information on dead partitions. Related Commands container commands: I container create mirror (page 3-5) I container list (page 3-50) I container promote (page 3-63) disk commands: I disk remove dead_partitions (page 5-10) 3-11