Adaptec 2020ZCR Reference Guide - Page 75
The following example extends a multilevel volume set array 0
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
container Commands Examples Before extending a multilevel volume set, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a multilevel volume set) on this controller. In addition, the example shows array 1 and array 2 (both volume sets created with the container create volume command). AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 10MB NTFS 63 Volume 10MB 0:02:0 64.0KB: 10.0MB 1 Volume 15MB None 0:03:0 64.0KB: 15.0MB 2 Volume 15MB None 0:04:0 64.0KB: 15.0MB The following example extends a multilevel volume set (array 0) by adding arrays 1 and 2 (which are both volume sets): AAC0>container extend mvolume 0 1 2 Executing: container extend mvolume 0 1 2 container 0 extended As the command executes, note that the title bar of the DOS window displays the status of the command. For example: Stat:OK!Task:102,Func:FSX Ctr:0,State:RUN 84.3% For further details on status information, see page 1-13. Use the container list command after using the container extend mvolume command to display information about the multilevel array of volume sets after you extend it, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 40MB NTFS 63 Volume 10MB 0:02:0 64.0KB: 10.0MB 62 Volume 15MB 0:03:0 64.0KB: 15.0MB 61 Volume 15MB 0:04:0 64.0KB: 15.0MB 3-44