Adaptec 2020ZCR Reference Guide - Page 244
enclosure prepare slot
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 244 highlights
enclosure Commands enclosure prepare slot To indicate to the SAF-TE enclosure management device that it should take the appropriate action to prepare the device in a specific slot for removal or insertion, use the enclosure prepare slot command. This command may perform such operations as shutting off power to the device slot. This allows users to safely remove a disk device from or insert a disk device into the device slot. Syntax enclosure prepare slot {enclosure} {slot} Parameters {enclosure} Specifies the ID associated with the enclosure management device on which you want to prepare a slot. For this version, the controller supports a maximum of eight enclosure management devices on each bus. {slot} Specifies the unit number associated with the slot. This is the slot that contains the device you want to prepare to make available. This unit number can range from 0 to 15 inclusive. Examples Before preparing a device in the slot, you might want to use the enclosure show slot command to determine the current device slot status: AAC0>enclosure show slot Executing: enclosure show slot Enclosure Slot scsiId Insert Status 0 0 0:00:0 4 OK UNCONFIG ACTIVATE 0 1 0:01:0 0 OK UNCONFIG ACTIVATE 0 2 0:10:0 0 OK UNCONFIG ACTIVATE 0 3 0:03:0 0 OK UNCONFIG ACTIVATE 0 4 0:04:0 0 OK UNCONFIG ACTIVATE 1 0 1:00:0 0 OK CONFIG ACTIVATE 1 1 1:01:0 0 OK UNCONFIG ACTIVATE 1 2 1:10:0 0 OK UNCONFIG ACTIVATE 1 3 1:03:0 0 OK UNCONFIG ACTIVATE 1 4 1:04:0 0 OK UNCONFIG ACTIVATE 9-11