Adaptec 2020ZCR Reference Guide - Page 130
container set io_delay
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
container Commands container set io_delay To set the I/O delay for an array, use the container set io_delay command. You can specify an I/O delay for the following array-related tasks: I Creating a mirror set I Creating a multilevel array of mirror sets from a multilevel array of volume sets I Scrubbing a redundant array You use this command to change the I/O delay from the one you specified in the command for the previously listed tasks. The I/O delay value is not preserved between reboots of the operating system. Syntax container set io_delay {container} {integer} Parameters {container} Specifies the ID number (0 to 63) of the array on which to set the I/O delay. {integer} Specifies the number of milliseconds the controller waits between the I/O operations required to perform the specified background task. The I/O delay value is not preserved between reboots of the operating system. Valid values are 0 through 100. Examples Before setting the I/O delay on an array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB 3-99