Adaptec 2020ZCR Reference Guide - Page 52
container create raid5, determine the number of buses it actually supports.
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
container Commands container create raid5 To create a RAID 5 array, use the container create raid5 command. The RAID 5 array must have a minimum of three disks. When creating the RAID 5 array, you must initialize the array parity by using the scrub method (the /scrub switch). Notes If you created a RAID 5 array you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create raid5 [/cache{=boolean}] [/clear{=boolean}] [/stripe_size{=integer}] [/label{=string}] [/scrub{=boolean}] [/wait{=boolean}] {free_space} [{scsi_device}...] Parameters {free_space} Specifies the SCSI device and its associated freespace used to create the RAID 5 array. For further details, see free_space on page 1-11. {scsi_device}... Specifies one or more SCSI devices. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the installation guide for your controller to determine the number of buses it actually supports. For further details, see scsi_device on page 1-10. The command uses the freespace(s) from the SCSI device(s) you specify to create the RAID 5 array. The size that the command uses from these device(s) is identical to the one you specify in the free_space parameter. The minimum number of partitions in a RAID 5 array is 3, and the maximum number of partitions is 16. 3-21