Adaptec 2020ZCR Reference Guide - Page 36
container create mirror
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
container Commands container create mirror To create a mirror set from a single-partition volume set and freespace, use the container create mirror command. Any data on the original volume set remains intact during mirror creation and the user sees no interruption in service. If you created a mirror set on a NetWare server, you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create mirror [/wait{=boolean}] [/io_delay{=integer}] {container} {scsi_device} Parameters {container} Specifies the ID number (0 to 63) of the array on which to create a mirror set. You create a mirror set from a singlepartition volume set. {scsi_device} Specifies the ID for the SCSI device whose freespace you want to use for mirroring the volume set specified in the container parameter. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). Refer to your controller's Installation and User's Guide to determine the number of buses it supports. For further details, see scsi_device on page 1-10. 3-5