Adaptec 2020ZCR Reference Guide - Page 113

container Commands container remove file_system To remove the file system from an array, use the container remove file_system command. Use this command when the file system on the array is no longer needed. This command fails if there are open files on the array. Command Availability This command is supported on Windows. Syntax container remove file_system {container} Parameters {container} Specifies the ID number (0 to 63) of the array from which you want to remove the file system. Examples Before removing a file system from an array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB 3-82