Adaptec 2020ZCR Reference Guide - Page 44
stripe_size{=integer}, label{=string}, container set label, container list, container create mirror - scsi raid controller
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
container Commands {container}... Specifies the ID number or numbers (0 to 63) of one or more arrays from which you want to create the multilevel stripe set. You can use up to 16 arrays to create a multilevel stripe set. All specified arrays must be the same size as the first container parameter and separated by blank spaces. Switches /stripe_size{=integer} Note: This keyword does not support RAID 50 arrays because RAID 50 arrays support only a stripe size of 64 KB. Specifies the stripe size for the multilevel stripe set. Valid values are 16 KB, 32 KB, and 64 KB. If you do not specify the switch, it defaults to 64 KB. /label{=string} Specifies a label to be assigned to the newly created multilevel stripe set. You can specify a maximum of sixteen characters for the label. If you do not specify the switch, it defaults to no label. If you do not specify a label, you can do so later by using the container set label command. Examples Before creating a multilevel stripe set, use the container list command to obtain information about any existing arrays. As the following example shows, there are two existing arrays (mirror sets) on this controller at the time the multilevel stripe set is created. These mirror sets were previously created with the container create mirror command. AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Mirror 15MB None 0:02:0 64.0KB: 15.0MB 0:02:0 15.0MB: 15.0MB 1 Mirror 15MB None 0:03:0 64.0KB: 15.0MB 0:03:0 15.0MB: 15.0MB 3-13