Adaptec 2020ZCR Reference Guide - Page 134
container show cache
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
container Commands container show cache To display the current cache parameters associated with a specific array, use the container show cache command. Typically, you use this command after setting cache parameters for a specific array using the container set cache command. Syntax container show cache {container} Parameters {container} Specifies the ID number (0 to 63) of the array whose associated cache parameters you want to display. Examples Before setting cache parameters for a specific array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller with no file system on it (as evidenced by None displayed in the Usage column). Assume the cache parameters for this array were previously set with the container set cache command: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MB The following example displays cache parameters for array 0: AAC0>container show cache 0 Executing: container show cache 0 Global container Read Cache Size : 5345280 Global container Write Cache Size : 1970176 Read Cache Setting : ENABLED Write Cache Setting : ENABLED Write Cache Status : ENABLED 3-103