Adaptec 2020ZCR Reference Guide - Page 76

container Commands The following list describes the change to the display as the result of extending a multilevel array with the container extend mvolume command: I The Num Label column continues to display the ID number (0) of the volume set previously created with the container create volume command and the ID number (63) of the volume set previously created with the container add_level command. In addition, the column displays the ID numbers (in this example, 62 and 61) of the volume sets created as a result of the container extend mvolume command. If you specified labels when creating the volume sets, they appear in this column. Because no labels were specified when the volume sets were created, no labels appear in the column. I The Type column continues to display Volume to indicate that the arrays previously created with the container create volume and the container add_level commands are volume sets. In addition, the column displays Volume for the volume sets created as a result of the container extend mvolume command. I The Total Size column displays a new total size, taking into account the freespaces associated with the volume sets created as a result of the container create volume and the container add_level commands. I The Scsi C:ID:L column displays the SCSI IDs for the devices on which the volume sets were created, which in the example are 0:02:0, 0:03:0, and 0:04:0. I The Partition Offset:Size column displays the offsets and sizes for the partition(s) on which the volume sets were created, which in the example are 64.0KB:10MB, 64.0KB:15.0MB, and 64KB:15MB. If a partition is dead, the ":" (colon) in the Partition Offset:Size column changes to a "!" (exclamation point). See the disk remove dead_partitions (page 5-10) command for more information on dead partitions. 3-45