Adaptec 2020ZCR Reference Guide - Page 58
container create stripe
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
container Commands container create stripe To create a stripe set from freespace, use the container create stripe command. Notes If you created a stripe set you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create stripe [/cache{=boolean}] [/stripe_size{=integer}] [/label{=string}] {free_space} [{scsi_device}...] Parameters {free_space} Specifies the SCSI device and its associated freespace used to create the stripe set. For further details, see free_space on page 1-11. {scsi_device}... Specifies one or more SCSI devices. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the installation guide for your controller to determine the number of buses it actually supports. For further details, see scsi_device on page 1-10. The command uses the freespace(s) from the SCSI device(s) to create the stripe set. The size from the device is identical to the one you specify in the free_space parameter. The minimum number of partitions for a stripe set is 2, and the maximum number is 16. 3-27