Adaptec 2020ZCR Reference Guide - Page 109
container remove drive_letter
![]() |
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
container Commands container remove drive_letter To remove a drive letter, use the container remove drive_letter command. To use the container remove drive_letter command, none of the array's files can be open. Command Availability This command is supported on Windows. Syntax container remove drive_letter {string} Parameters {string} Specifies the drive letter to remove. The colon (:) after the drive letter is optional. Examples Before removing a drive letter from an array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller with a drive letter F: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB The following example removes drive letter F from array 0: AAC0> container remove drive_letter F Executing: container remove drive_letter "F" Use the container list command after using the container remove drive_letter command to display information about the array on which you just removed a drive letter, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB 3-78
![](/manual_guide/products/adaptec-2020zcr-reference-guide-57716a2/109.png)