Adaptec 2020ZCR Reference Guide - Page 63
container create volume
UPC - 760884151136
View all Adaptec 2020ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
container Commands container create volume To create a volume set from freespace, use the container create volume command. Notes If you created a volume set you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create volume [/cache{=boolean}] [/ label{=string}] {scsi_device},{free_space} [{scsi_device},{free_space}...] Parameters {scsi_device} Specifies the ID for the SCSI device whose freespace you want to use for creating the volume set. A SCSI ID consists of a SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the installation guide for your controller to determine the number of buses it actually supports. For further details, see scsi_device on page 1-10. Note that you must explicitly specify the entire ID for the SCSI device (the SCSI channel number, device ID, and device logical unit number). {free_space} Specifies the freespace used to create the volume set on the specified SCSI device. For further details, see free_space on page 1-11. 3-32