Adaptec 2020ZCR Reference Guide - Page 165

controller Commands controller set array_verify To enable or disable the array verify operation, use the controller set verify command. This command allows you to enable or disable the array verify operation for all arrays controlled by the specified controller. Syntax controller set array_verify [/verify_enabled{=boolean}] /verify_enabled{=boolean} Specifies whether to turn on or off the array verify feature on the specified controller. You must set this switch to TRUE if you want to turn on array verify for all arrays associated with the specified controller. To turn off the array verify feature on the specified controller, set this switch to FALSE. The command defaults to TRUE, which means the command turns on the array verify feature on the specified controller. Examples Before turning the array verify feature on or off, check its status by using the controller show array_verify command. The following example shows that the controller's array verify feature is currently disabled: AAC0> controller show array_verify Executing: controller show array_verify Array verify DISABLED The following example turns on (enables) the array verify feature for the currently opened controller: AAC0> controller set array_verify /verify_enabled Executing: controller set array_verify /verify_enabled=TRUE The controller show array_verify command indicates that the controller's array verify feature is currently enabled. The command also displays the number of errors (if any) found as a result of the array verify operation. AAC0> controller show array_verify Executing: controller show array_verify Array verify ENABLED Errors found 0 4-19