Brother International SE-270D Users Manual - English - Page 161
Nothing appears in the LCD, Operation beep
View all Brother International SE-270D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Nothing appears in the LCD If nothing appears in the LCD when the sewing machine is turned on, the brightness of the LCD is either too light or too dark. If this is the case, perform the following operation. Turn off the sewing machine. a Turn the power on while pressing any of the b display panel buttons. Operation beep Each time a key is pressed or an incorrect operation is performed, a beep is sounded. ■ For a correct operation One beep is sounded. ■ If an incorrect operation is performed Two or four beeps are sounded. ■ If the machine locks up, for example, because the thread is tangled The sewing machine continues to beep for four seconds. The machine automatically stops. Be sure to check for the cause of the error, and correct it before continuing to sew. Press or . c 5 Turn off the sewing machine, then turn it on d again. Troubleshooting 155