Brother International SE-270D Users Manual - English - Page 93
wheel toward you to check that
View all Brother International SE-270D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Select stitch 3 . h When you are about 5 cm (2 inch) from the j end of the zipper, stop the sewing machine with the needle lowered (in the fabric), raise the presser foot lever. Open the zipper and continue sewing. k • For details, refer to "Selecting stitching" (page 45). CAUTION ● When using zipper foot "I", be sure to select the straight stitch (center needle position), and slowly turn the balance wheel toward you to check that the needle does not touch the presser foot. If Close the zipper, turn over the fabric, and then 3 l baste the other side of the zipper to the fabric. a different stitch is selected or the needle hits the presser foot, the needle may bend or break. Sew the zipper to the piece of fabric with the i extra 3 mm (1/8 inch), starting from the base of the zipper. 1 CAUTION ● When sewing, be sure that the needle does not touch the zipper, otherwise the needle may bend or break. a Basting stitching Attach the presser foot holder to the other pin m of zipper foot "I". If the presser foot holder was attached to the right pin in step g, change it to the left pin. 1 I 2 a Pin on the left side b Needle drop point Zipper Insertion 87