Brother International SE-270D Users Manual - English - Page 24
the bobbin winder seat, the thread may
View all Brother International SE-270D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
GETTING READY Memo z When using thread that winds off quickly, such as transparent nylon thread or metallic thread, place the spool net over the spool before placing the spool of thread onto the spool pin. If the spool net is too long, fold it to fit the size of the spool. 1 Pull the thread to the right and pass it through j the slit in the bobbin winder seat. 1 a Slit in bobbin winder seat (with built-in cutter) X The thread is cut to a suitable length. 4 3 2 a Spool net b Spool c Spool pin d Spool cap Pull out some thread, and then thread the h thread guide for bobbin winding. Be sure that the thread is fully in the two thread guides for bobbin winding. 1 CAUTION ● Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out. Slide the sewing speed controller to the right k (so that the speed will be fast). 1 2 a Sewing speed controller Press l (Start/stop button) once. a Thread guide for bobbin winding b Two slits Wind the thread that was pulled out onto the i bobbin. Wind the thread that was pulled clockwise five or six times without any slack. 18 1 a Start/stop button • If it does not start when the start/stop button is pressed, an animation is displayed on the LCD. Press the start/stop button after touching the LCD.