Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1023

57 Upgrade Procedures For detailed upgrade procedures, refer to the Dell Networking OS Release Notes for your switch. The release notes describe the requirements and steps to follow to upgrade to a desired OS version. Upgrade Overview To upgrade system software on the switch, follow these general steps: 1. Identify the boot and system images currently stored on the switch (Control Processor, Route Processor, and line-card CPUs) using the show boot system all command. 2. Upgrade the operating system image using the following commands: • upgrade system • boot system • write memory • reload 3. Upgrade the bootflash and bootselector images (if necessary) using the upgrade boot bootflash-image and upgrade boot bootselector-image commands. Then reload the switch. For detailed upgrade procedures, refer to the Release Notes. Get Help with Upgrades Direct any questions or concerns about the OS upgrade procedures to the Dell Technical Support Center. You can reach Technical Support: • On the web: http://support.dell.com/ • By email: [email protected] • By phone: US and Canada: 866.965.5800, International: 408.965.5800. Bootup and Upgrades The switch has multiple CPUs that boot up at the same time but separately from one another. The switch supports bootups from a network-server download as well as from the local flash. Each CPU has a local flash with multiple partitions, including partitions A and B where system images are stored. All CPUs must be configured to boot up in the same way: • Using a software image stored on a network server (network boot) and downloaded on the switch or stored in the local flash (flash boot) • When booting from the local flash, boot up with an image stored in the same partition: A or B. A firmware upgrade includes upgrades for the system image, BIOS, and bootcode. Use the upgrade command to upgrade the switch firmware by downloading an image from a network server or from the Upgrade Procedures 1023