Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 760

given port number psh range range of port numbers rst syn urg Match on the psh bit Match only packets in the Match on the rst bit Match on the syn bit Match on the urg bit cr Dell(conf-redirect-list)#redirect 1.1.1.1 udp any any ? eq Match only packets on a given port number gt Match only packets with a greater port number lt Match only packets with a lower port number neq Match only packets not on a given port number range Match only packets in the range of port numbers Delete a rule with the no redirect command. The redirect rule supports Non-contiguous bitmasks for PBR in the Destination router IP address The below step shows a step-by-step example of how to create a rule for a redirect list by configuring: • IP address of the next-hop router in the forwarding route • IP protocol number • Source address with mask information • Destination address with mask information Creating a Rule Example: Dell(conf-redirect-list)#redirect ? A.B.C.D Forwarding router's address Dell(conf-redirect-list)#redirect 3.3.3.3 ? An IP protocol number icmp Internet Control Message Protocol ip Any Internet Protocol tcp Transmission Control Protocol udp User Datagram Protocol Dell(conf-redirect-list)#redirect 3.3.3.3 ip ? A.B.C.D Source address any Any source host host A single source host Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 ? Mask A.B.C.D or /nn Mask in dotted decimal or in slash format Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 ? A.B.C.D Destination address any Any destination host host A single destination host Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 77.1.1.1 ? Mask A.B.C.D or /nn Mask in dotted decimal or in slash format Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 77.1.1.1 /32 ? Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 77.1.1.1 /32 760 Policy-based Routing (PBR)