Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 929

EXEC Privilege mode ssh {hostname} [-l username | -p port-number | -v {1 | 2} hostname is the IP address or host name of the remote device. Enter an IPv4 or IPv6 address in dotted decimal format (A.B.C.D). • Configure the Dell Networking system as an SCP/SSH server. CONFIGURATION mode ip ssh server {enable | port port-number} • Configure the Dell Networking system as an SSH server that uses only version 1 or 2. CONFIGURATION mode ip ssh server version {1|2} • Display SSH connection information. EXEC Privilege mode show ip ssh Specifying an SSH Version The following example shows using the ip ssh server version 2 command to enable SSH version 2 and the show ip ssh command to confirm the setting. Dell(conf)#ip ssh server version 2 Dell(conf)#do show ip ssh SSH server : disabled. SSH server version : v2. Password Authentication : enabled. Hostbased Authentication : disabled. RSA Authentication : disabled. To disable SSH server functions, use the no ip ssh server enable command. Using SCP with SSH to Copy a Software Image To use secure copy (SCP) to copy a software image through an SSH connection from one switch to another, use the following commands. 1. On Switch 1, set the SSH port number (port 22 by default). CONFIGURATION mode ip ssh server port number 2. On Switch 1, enable SSH. CONFIGURATION mode ip ssh server enable 3. On Switch 2, invoke SCP. CONFIGURATION mode copy scp: flash: 4. On Switch 2, in response to prompts, enter the path to the desired file and enter the port number specified in Step 1. Security 929