Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 824

no ip address portmode hybrid switchport service-policy input phone-pc power inline auto no shutdown Dell#sh run int gi 0/6/2 ! interface GigabitEthernet 0/6/2 description "Uplink to C9000" no ip address switchport service-policy output BW no shutdow Managing PoE on the Port Extender This section describes how to manage PoE on the port extender. Upgrading the PoE Controller To upgrade the PoE controller firmware on a port extender, use the following command. You can upgrade the PoE controller firmware using the firmware packaged with the Dell Networking OS. After the upgrade is successful, the port extender reloads automatically. NOTE: You cannot upgrade the PoE controller when any other upgrade is in progress. Upgrading the PoE controller may take a few minutes to complete. Also, the CLI is blocked until the upgrade is complete. 1. Upgrade the PoE controller. EXEC Privilege mode upgrade poe-controller pe pe-id stack-unit unit-number 2. Verify the PoE controller firmware version that the PE is using. EXEC Privilege Dell# show revision pe pe-id stack-unit unit-number -- Port Extender 2 1 -PoE-Controller version : 2.65 3. Verify the PoE version bundled with the booted Dell Networking OS image. Dell# show os-version PoE-CONTROLLER IMAGE INFORMATION : Type Version Target PoE Controller 2.65 Port Extender C1048P Suspending Power Delivery on the Port Extender You can temporarily disable and then restore power on the port extender. For information about how to restore power to the port extender, see Restoring Power Delivery on the PE. To disable inline power on the port extender, use the following command. When you use this command, the inline power to all the ports on the port extender are disabled. 824 Power over Ethernet (PoE)