Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1119

belonging to either subnet 50.1.1.0/24 or subnet 60.1.1.0/24, but not from both subnets (though the system allows the same). • If the virtual IP address and the interface's primary/secondary IP address are the same, the priority on that VRRP group MUST be set to 255. The interface then becomes the OWNER router of the VRRP group and the interface's physical MAC address is changed to that of the owner VRRP group's MAC address. • If you configure multiple VRRP groups on an interface, only one of the VRRP Groups can contain the interface primary or secondary IP address. Configuring a Virtual IP Address To configure a virtual IP address, use the following commands. 1. Configure a VRRP group. INTERFACE mode vrrp-group vrrp-id The VRID range is from 1 to 255. 2. Configure virtual IP addresses for this VRID. INTERFACE -VRID mode virtual-address ip-address1 [...ip-address12] The range is up to 12 addresses. Examples of the Configuring and Verifying a Virtual IP Address The following example shows how to configure a virtual IP address. Dell(conf-if-te-1/1/1-vrid-111)#virtual-address 10.10.10.1 Dell(conf-if-te-1/1/1-vrid-111)#virtual-address 10.10.10.2 Dell(conf-if-te-1/1/1-vrid-111)#virtual-address 10.10.10.3 The following example shows how to verify a virtual IP address configuration. NOTE: In the following example, the primary IP address and the virtual IP addresses are on the same subnet. Dell(conf-if-te-1/1/1)#show conf ! interface TenGigabitEthernet 1/1/1 ip address 10.10.10.1/24 ! vrrp-group 111 priority 255 virtual-address 10.10.10.1 virtual-address 10.10.10.2 virtual-address 10.10.10.3 ! vrrp-group 222 no shutdown The following example shows the same VRRP group (VRID 111) configured on multiple interfaces on different subnets. Dell#show vrrp TenGigabitEthernet 1/1/1, VRID: 111, Net: 10.10.10.1 State: Master, Priority: 255, Master: 10.10.10.1 (local) Virtual Router Redundancy Protocol (VRRP) 1119