Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 62

Example of EXEC Privilege Commands The configuration in the following example creates privilege level 3. This level: removes the resequence command from EXEC mode by requiring a minimum of privilege level 4 moves the capture bgp-pdu max-buffer-size command from EXEC Privilege to EXEC mode by requiring a minimum privilege level 3, which is the configured level for VTY 0 allows access to CONFIGURATION mode with the banner command allows access to INTERFACE and LINE modes are allowed with no commands. Dell(conf)#do show run priv ! privilege exec level 3 capture privilege exec level 3 configure privilege exec level 4 resequence privilege exec level 3 capture bgp-pdu privilege exec level 3 capture bgp-pdu max-buffer-size privilege configure level 3 line privilege configure level 3 interface Dell(conf)#do telnet 10.11.80.201 [telnet output omitted] Dell#show priv Current privilege level is 3. Dell#? capture Capture packet configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC ip Global IP subcommands monitor Monitoring feature mtrace Trace reverse multicast path from destination to source ping Send echo messages quit Exit from the EXEC show Show running system information [output omitted] Dell#config [output omitted] Dell(conf)#do show priv Current privilege level is 3. Dell(conf)#? end Exit from configuration mode exit Exit from configuration mode interface Select an interface to configure line Configure a terminal line linecard Set line card type Dell(conf)#interface ? loopback Loopback interface managementethernet Management Ethernet interface peGigE PE Gigabit Ethernet interface null Null interface port-channel Port-channel interface range Configure interface range tengigabitethernet TenGigabit Ethernet interface vlan VLAN interface Dell(conf)#interface tengigabitethernet 1/1 Dell(conf-if-te-1/1)#? end Exit from configuration mode exit Exit from interface configuration mode Dell(conf-if-te-1/1)#exit Dell(conf)#line ? aux Auxiliary line 62 Switch Management