Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 52

Password to login remote host: ! Example of Copying to NFS Mount Dell#copy flash://test.txt nfsmount:// Destination file name [test.txt]: ! 15 bytes successfully copied Dell#copy flash://ashu/capture.txt.pcap nfsmount:// Destination file name [test.txt]: ! 15 bytes successfully copied Dell#copy flash://ashu/capture.txt.pcap nfsmount://username/snoop.pcap ! 24 bytes successfully copied Dell# Dell#copy tftp://10.16.127.35/username/dv-maa-C9010-test ? flash: Copy to local file system ([flash://]filepath) nfsmount: Copy to nfs mount file system (nfsmount://filepath) running-config remote host: Destination file name [test.c]: ! 225 bytes successfully copied Dell# Default Configuration Although a version of the Dell Networking OS is pre-loaded on the switch, the system is not configured when you power up the first time (except for the default hostname, which is Dell). You must configure the system using the CLI. Configuring a Host Name The host name appears in the prompt. The default host name is Dell. • Host names must start with a letter and end with a letter or digit. • Characters within the string can be letters, digits, and hyphens. To create a host name, use the following command. • Create a host name. CONFIGURATION mode hostname name Example of the hostname Command Dell(conf)#hostname R1 R1(conf)# Accessing the System Remotely You can configure the system to access it remotely by Telnet or SSH. • The switch has a dedicated management port and a management routing table that is separate from the IP routing table. 52 Getting Started