Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 762

To ensure that the permit statement or PBR exception is effective, use a lower sequence number, as shown below: ip redirect-list rcl0 seq 10 permit ip host 3.3.3.3 any seq 15 redirect 2.2.2.2 ip any any Apply a Redirect-list to an Interface using a Redirect-group IP redirect lists are supported on physical interfaces as well as VLAN and port-channel interfaces. NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and the destination port-channel is shut down, the traffic is dropped. Use the following command inINTERFACE mode to apply a redirect list to an interface. Multiple redirectlists can be applied to a redirect-group. It is also possible to create two or more redirect-groups on one interface for backup purposes. Table 64. Applying a Redirect-list to an Interface Command Syntax Command Mode Purpose ip redirect-group redirect-list-name INTERFACE Apply a redirect list (policy-based routing) to an interface. redirect-list-name is the name of a redirect list to apply to this interface. FORMAT: up to 16 characters Delete the redirect list from this interface with the [no] ip redirect-group command. In this example, the list "xyz" is applied to the tenGigabitEthernet 2/1 interface. Applying a Redirect-list to an Interface Example: Dell(conf-if-te-1/1/1)#ip redirect-group test Dell(conf-if-te-1/1/1)#ip redirect-group xyz Dell(conf-if-te-1/1/1)#show config ! interface TenGigabitEthernet 1/1/1 no ip address ip redirect-group test ip redirect-group xyz shutdown Dell(conf-if-te-1/1/1)# In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface. Dell Networking OS has the capability to support multiple groups on an interface for backup purposes. Show Redirect List Configuration To view the redirect list configuration, use the following command in EXEC mode: 762 Policy-based Routing (PBR)