Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 539

L fe80::/10 [0/0] Direct, Nu 0, 00:34:42 Dell#show ipv6 route static Destination Dist/Metric, Gateway, Last Change S 8888:9999:5555:6666:1111:2222::/96 [1/0] via 2222:2222:3333:3333::1, Te 9/1, 00:03:16 S 9999:9999:9999:9999::/64 [1/0] via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16 Displaying the Running Configuration for an Interface To view the configuration for any interface, use the following command. • Display the currently running configuration for the specified interface. EXEC mode show running-config interface type {slot/port} Enter the keyword interface then the type of interface and slot/port information: - For the management interface, enter the keyword ManagementEthernet 0/0. - For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. - For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. Example of the show running-config interface Command Dell#show run int te 2/2 ! interface TenGigabitEthernet 2/2 no ip address ipv6 address 3:4:5:6::8/24 shutdown Dell# Clearing IPv6 Routes To clear routes from the IPv6 routing table, use the following command. • Clear (refresh) all or a specific route from the IPv6 routing table. EXEC mode clear ipv6 route {* | ipv6 address prefix-length} - *: all routes. - ipv6 address: the format is x:x:x:x::x. - mask: the prefix length is from 0 to 128. NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated by a colon (:). Omitting zeros is accepted as described in Addressing. IPv6 Routing 539