Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 706

EXEC Privilege mode clear ip ospf process-id • View the current OSPFv2 status. EXEC mode show ip ospf process-id Example of Viewing the Current OSPFv2 Status Dell#show ip ospf 55555 Routing Process ospf 55555 with ID 10.10.10.10 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 Dell# Enabling Multi-Process OSPF (OSPFv2, IPv4 Only) Multi-process OSPF allows multiple OSPFv2 processes on a single router. For more information, refer to Multi-Process OSPF (OSPFv2, IPv4 Only) When configuring a single OSPF process, follow the same steps previously described. Repeat them as often as necessary for the desired number of processes. After the process is created, all other configurations apply as usual. 1. Assign an IP address to an interface. CONFIG-INTERFACE mode ip address ip-address mask Format: A.B.C.D/M. If you are using a Loopback interface, refer to Loopback Interfaces. 2. Enable the interface. CONFIG-INTERFACE mode no shutdown 3. Return to CONFIGURATION mode to enable the OSPFv2 process globally. CONFIGURATION mode router ospf process-id [vrf] The range is from 0 to 65535. After the OSPF process and the VRF are tied together, the OSPF process ID cannot be used again in the system. If you try to enable more OSPF processes than available Layer 3 interfaces, the following message displays: Dell(conf)#router ospf 1 % Error: No router ID available. 706 Open Shortest Path First (OSPFv2 and OSPFv3)