Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 813

and 30.0 W for PoE+. No dynamic PoE/PoE+ class detection performs on Static ports. The default Power Management mode is static. • pe pe-id - Specify the port extender ID. The range is from 0 to 255. • stack-unit unit-number - Specify the stack unit number of the port extender. The range is from 0 to 7. • Enable PoE and configure Power Management mode on a port extender. Configuration mode power inline mode pe pe-id stack-unit unit-number{static | class} Example: Configuring Power Management Static Mode on the Port Extender The following example configures the power management to Static mode on the port extender 0 on stack unit 0. Dell(conf)#power inline mode pe 0 stack-unit 0 static Example: Displaying PoE Power Allocation on a Port Extender The following example displays the PoE power allocation on a specified port extender, using the show power inline {pe pe-id stack-unit unit number | interface interface } command in EXEC and EXEC Privilege mode. Dell#show power inline pe 0 stack-unit 0 Global inline power Threshold : 99 Power Reserved for inline Power :841W Total Inline Power Consumed: 0W Remaining inline power Available :841W Power Management Mode : Static Interface Inline Power Inline Power Class Device PoE Port LLDP Max / Alloc Consumed Type Priority Support (Watts) (Watts) PeGi 0/0/0 30.00/0.00 0.00 NO_PD - low 0 Allocate PoE Power to Powered Devices to a Connected PE Interface To enable inline power and configure the maximum power allocation and priority for the powered device connected to a port extender interface, use the power inline {[max_milliwatts] | priority {critical | high | low}} command in Interface mode. By default, power inline is disabled. Port Prioritization To specify the priority on a particular interface on the port extender, use the power inline priority command. When you reduce the inline power available in a port extender, the lower priority interfaces are disabled initially then the higher priority interfaces are disabled. Between equal priority ports, the port number determines which port is assigned the higher priority. Port 0 has the highest priority and port 47 has the lowest priority. For more information, see Managing Power Priorities and Managing Ports using Power Priority and the Power Budget. On a port extender interface, you can configure one of the following priority levels: critical, high, and low. By default, all ports are set to low. When you reduce the available inline power, the order of priority for disabling the inline power to the interfaces is as follows: Power over Ethernet (PoE) 813