Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 51

the mount-point to which you want to load the system. The /f10/mnt/nfsdirectory is the root of all mount-points. To mount an NFS file system, perform the following steps: Table 3. Mounting an NFS File System File Operation Syntax To mount an NFS file system: mount nfs rhost:path mount-point username password The foreign file system remains mounted as long as the device is up and does not reboot. You can run the file system commands without having to mount or un-mount the file system each time you run a command. When you save the configuration using the write command, the mount command is saved to the startup configuration. As a result, each time the device re-boots, the NFS file system is mounted during start up. Table 4. Forming a copy Command Location source-file-url Syntax For a remote file location: NFS File System copy nfsmount://{}/filepath/ filename} username:password destination-file-url Syntax tftp://{hostip | hostname}/filepath/ filename Important Points to Remember • You cannot copy a file from one remote system to another. • You cannot copy a file from one location to the same location. • When copying to a server, you can only use a hostname if a domain name server (DNS) server is configured. • The usbflash command is supported on the device. Refer to your system's Release Notes for a list of approved USB vendors. Example of Copying a File to current File System Dell#copy tftp://10.16.127.35/username/dv-maa-C9010-test nfsmount:// Destination file name [dv-maa-sC9010-test 44250499 bytes successfully copied Dell# Dell#copy ftp://10.16.127.35 nfsmount: Source file name []: test.c User name to login remote host: username Example of Logging in to Copy from NFS Mount Dell#copy nfsmount://test flash: Destination file name [test]: test2 ! 5592 bytes successfully copied Dell# Dell#copy nfsmount://test.txt ftp://10.16.127.35 Destination file name [test.txt]: User name to login remote host: username Getting Started 51