Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 748

To display the expiry time configuration, use the show running-configuration pim command from EXEC Privilege mode. Configuring a Static Rendezvous Point The rendezvous point (RP) is a PIM-enabled interface on a router that acts as the root a group-specific tree; every group must have an RP. • Identify an RP by the IP address of a PIM-enabled or Loopback interface. ip pim rp-address Example of Viewing an RP on a Loopback Interface Dell#sh run int loop0 ! interface Loopback 0 ip address 1.1.1.1/32 ip pim sparse-mode no shutdown Dell#sh run pim ! ip pim rp-address 1.1.1.1 group-address 224.0.0.0/4 Overriding Bootstrap Router Updates PIM-SM routers must know the address of the RP for each group for which they have (*,G) entry. This address is obtained automatically through the bootstrap router (BSR) mechanism or a static RP configuration. Use the following command if you have configured a static RP for a group. If you do not use the override option with the following command, the RPs advertised in the BSR updates take precedence over any statically configured RPs. • Use the override option to override bootstrap router updates with your static RP configuration. ip pim rp-address Examples of Viewing the Rendezvous Point (Multicast Group) Information To display the assigned RP for a group, use the show ip pim rp command from EXEC privilege mode. Dell#show ip pim rp Group RP 225.0.1.40 165.87.50.5 226.1.1.1 165.87.50.5 To display the assigned RP for a group range (group-to-RP mapping), use the show ip pim rp mapping command in EXEC privilege mode. Dell#show ip pim rp mapping PIM Group-to-RP Mappings Group(s): 224.0.0.0/4, Static RP: 165.87.50.5, v2 748 PIM Sparse-Mode (PIM-SM)