Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 77

To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode. Configuring FTP Client Parameters To configure FTP client parameters, use the following commands. • Specify an FTP interface source. CONFIGURATION mode ip ftp source-interface interface Enter the following keywords and slot/port or number information: - For a loopback interface, enter the keyword loopback then a number between 0 and 16383. - For a port channel interface, enter the keywords port-channel then a number from 1 to 255. - For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. - For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. - For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. • Configure a password. CONFIGURATION mode ip ftp password password • Enter a username to use on the FTP client. CONFIGURATION mode ip ftp username name To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode, as shown in the example for Enable FTP Server. Terminal Lines You can access the system remotely and restrict access to the system by creating user profiles. Terminal lines on the system provide different means of accessing the system. The console line (console) connects you through the console port. The virtual terminal lines (VTYs) connect you through a remote session to the system. Denying and Permitting Access to a Terminal Line Dell Networking recommends applying only standard access control lists (ACLs) to deny and permit access to VTY lines. • Layer 3 ACLs deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny traffic. • You cannot use the show ip accounting access-list command to display the contents of an ACL that is applied only to a VTY line. To apply an IP ACL to a line, Use the following command. • Apply an ACL to a VTY line. LINE mode Switch Management 77