Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 972

To send the SNMP version to use for notification messages, enter the keyword version. To identify the SNMPv1 community string, enter the name of the community-string. 2. Specify which traps the Dell Networking system sends to the trap receiver. CONFIGURATION mode snmp-server enable traps Enable all Dell Networking enterprise-specific and RFC-defined traps using the snmp-server enable traps command from CONFIGURATION mode. Enable all of the RFC-defined traps using the snmp-server enable traps snmp command from CONFIGURATION mode. 3. Specify the interfaces which send SNMP traps. CONFIGURATION mode snmp-server trap-source Example of RFC-Defined SNMP Traps and Related Enable Commands The following example lists the RFC-defined SNMP traps and the command used to enable each. The coldStart and warmStart traps are enabled using a single command. snmp authentication SNMP_AUTH_FAIL:SNMP Authentication failed.Request with invalid community string. snmp coldstart SNMP_COLD_START: Agent Initialized - SNMP COLD_START. SNMP_WARM_START:Agent Initialized - SNMP WARM_START. snmp linkdown PORT_LINKDN:changed interface state to down:%d snmp linkup PORT_LINKUP:changed interface state to up:%d Enabling a Subset of SNMP Traps You can enable a subset of Dell Networking enterprise-specific SNMP traps using one of the following listed command options. To enable a subset of Dell Networking enterprise-specific SNMP traps, use the following command. • Enable a subset of SNMP traps. snmp-server enable traps NOTE: The envmon option enables all environment traps including those traps that are enabled with the envmon supply, envmon temperature, and envmon fan options. The following traps are available. bgp traps config traps ecfm traps ecmp traps entity envmon Enable BGP state change Enable configuration Enable ECFM state change Enable ecmp Enable entity change traps Enable SNMP environmental monitor 972 Simple Network Management Protocol (SNMP)