Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 122

-- Chassis PE Cam ACL -- Current Settings(in block sizes) 1 block = 256 entries L2Acl : 5 Ipv4Acl : 2 Ipv6Acl : 2 Ipv4Qos : 2 L2Qos : 1 IpMacAcl : 0 Dell(conf)#cam-acl-pe ? default Reset PE CAM ACL entries to default setting l2acl Set L2-ACL entries Dell(conf)#cam-acl-pe l2acl 3 ipv4acl 2 ipv6acl 2 ipv4qos 2 l2qos 1 ipmacacl 2 Allocating CAM for Egress ACLs on the Port Extender To allocate Content Addressable Memory (CAM) for egress ACLs on the port extender. You can re-allocate memory space for egress ACLs on the port extender by using the cam-aclegress-pe command in CONFIGURATION mode. The default CAM allocation settings for the three egress ACL and QoS regions on an switch are • L2 ACL(l2acl): 1 • L3 ACL (ipv4acl): 1 • IPv6 L3 ACL (ipv6acl): 2 The total egress CAM ACL space must equal 4 memory blocks. The ranges of supported FP memory blocks are: You must allocate at least one block of memory to the L2ACL and IPv4 ACL regions. • L2 ACL(l2acl): 1 to 3 • L3 ACL (ipv4acl): 0 to 2 • IPv6 L3 ACL (ipv6acl): 0 to 4 You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. 1. Enter a CAM allocation action to perform on egress ACLs. Enter the number of FP blocks for each region. Separate each keyword and number with a blank space. The total CAM space allocated must equal 12. CONFIGURATION mode cam-acl-pe [default| l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number ipmacacl number ipv4pbr number] NOTE: Selecting default resets the CAM entries to the default settings. Select l2acl to reallocate memory space for egress ACL and QoS regions 2. Verify the details of CAM ACL egress profiles configured globally on the PE. It does not display CAM ACL egress profiles for each PE. The new settings will be written to CAM on the next reload. EXEC and EXEC Privilege mode show cam-acl-egress-pe 122 Access Control Lists (ACLs)