Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 270

TX MULTICAST ENTRY 0 0 0 TX INTER SPINE ENTRY 0 0 0 DROP ENTRY 0 0 0 CP bound IPC 847344 847344 0 RP bound IPC 9180 9180 0 ECP bound IPC 34484 34484 0 SFLOW_EGRESS 0 0 0 SFLOW_INGRESS 0 0 0 To clear the per-protocol counters of rate-limited control-plane traffic at the aggregated (switch) or line card and port set level, use the clear control-traffic protocol [cp-switch | linecard {0- 2} portset {0-3}] counters command; for example: Dell#clear control-traffic protocol linecard 1 portset 2 counters Dell# Dell#clear control-traffic protocol cp-switch counters Dell# Viewing Per-Queue CoPP Counters To view per-queue counters of CoPP rate-limited traffic, use the show control-traffic queue {all | queue-id queue-number} counters command. The range of queue-number values is from 0 to 20. The twenty-one control-plane queues are divided into groups of seven queues for the Route Processor, Control Processor, and line-card CPUs as follows: • Queues 0 to 6 process packets destined to the Control Processor CPU . • Queues 7 to 13 process packets destined to the Route Processor CPU. • Queues 14 to 20 process packets destined to the line card CPU. In the show output, Rx Counters displays the number of bytes of control-plane traffic received, on which queue-based rate limiting is applied. Tx Counters displays the number of bytes transmitted to a controlplane CPU after queue-based rate limiting is applied. Drop Counters displays the number of bytes of control-plane traffic that have been dropped as a result of queue-based rate limiting. Dell#show control-traffic queue queue-id 6 counters Queue-ID RxBytes TxBytes Drops ------- ----- Q6 24016 24016 0 Dell#show control-traffic queue all counters |no-more Queue-ID RxBytes TxBytes Drops ------- ----- Q0 0 0 0 Q1 0 0 0 Q2 0 0 0 Q3 0 0 0 Q4 0 0 0 Q5 0 0 0 Q6 21673 21673 0 Q7 0 0 0 Q8 0 0 0 Q9 0 0 0 270 Control Plane Policing (CoPP)