Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1068

If this scenario occurs, use the clear mac-address-table sticky all command on the primary or secondary peer to correctly sync the MAC addresses. • If static ARP is enabled on only one VLT peer, entries may be overwritten during bulk sync. Configuration Notes VLT requires that you enable the feature and then configure the same VLT domain, backup link, and VLT interconnect on both peer switches. When you configure VLT, the following conditions apply. • VLT domain - A VLT domain supports two chassis members, which appear as a single logical device to network access devices connected to VLT ports through a port channel. - A VLT domain consists of the two core chassis, the interconnect trunk, backup link, and the LAG members connected to attached devices. - Each VLT domain has a unique MAC address that you can configure using the system-mac command. If you do not specify a MAC address, VLT uses the primary peer's MAC address by default. - ARP tables are synchronized between the VLT peer nodes. - VLT peer switches operate as separate chassis with independent control and data planes for devices attached on non-VLT ports. - One chassis in the VLT domain is assigned a primary role; the other chassis takes the secondary role. The primary and secondary roles are required for scenarios when connectivity between the chassis is lost. VLT assigns the primary chassis role according to the lowest MAC address. You can configure the primary role. - In a VLT domain, the peer switches must run the same Dell Networking OS version. - Separately configure each VLT peer switch with the same VLT domain ID and the VLT version. If the system detects mismatches between VLT peer switches in the VLT domain ID or VLT version, the VLT Interconnect (VLTi) does not activate. To find the reason for the VLTi being down, use the show vlt mismatch command to verify that there are mismatch errors, then use the show vlt brief command on each VLT peer to view the VLT version on the peer switch. If the VLT version is more than one release different from the current version in use, the VLTi does not activate. - The chassis members in a VLT domain support connection to orphan hosts and switches that are not connected to both switches in the VLT core. • VLT interconnect (VLTi) - The VLT interconnect must consist of either 10G or 40G ports. A maximum of eight 10G or four 40G ports is supported. A combination of 10G and 40G ports is not supported. - A VLT interconnect over 1G ports is not supported. - The port channel must be in Default mode (not Switchport mode) to have VLTi recognize it. - The system automatically includes the required VLANs in VLTi. You do not need to manually select VLANs. - VLT peer switches operate as separate chassis with independent control and data planes for devices attached to non-VLT ports. - Port-channel link aggregation (LAG) across the ports in the VLT interconnect is required; individual ports are not supported. Dell Networking strongly recommends configuring a static LAG for VLTi. - The VLT interconnect synchronizes L2 and L3 control-plane information across the two chassis. - The VLT interconnect is used for data traffic only when there is a link failure that requires using VLTi in order for data packets to reach their final destination. - Unknown, multicast, and broadcast traffic can be flooded across the VLT interconnect. - MAC addresses for VLANs configured across VLT peer chassis are synchronized over the VLT interconnect on an egress port such as a VLT LAG. MAC addresses are the same on both VLT peer nodes. 1068 Virtual Link Trunking (VLT)