Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1056

NOTE: You can configure an IP address or subnet on a physical or VLAN interface that overlaps the same IP address or subnet configured on another interface only if the interfaces are assigned to different VRFs. If two interfaces are assigned to the same VRF, you cannot configure overlapping IP subnets or the same IP address on them. Table 92. Assigning an Interface to a VRF Task Command Syntax Command Mode Assign an interface to a VRF instance. ip vrf forwarding vrfname INTERFACE Assigning a Front-end Port to a Management VRF Starting in 9.7(0.0) release, you can assign a front-end port to a management VRF and make the port to act as a host interface. NOTE: You cannot assign loop-back and port-channel interfaces to a management port. To assign a front-end port to a management VRF, perform the following steps: Table 93. Assigning a Front-end port to a Management VRF Task Command Syntax Enter the front-end interface that interface you want to assign to a tengigabitethernet 1/1/1 management interface. Assign the interface to management VRF. ip vrf forwarding management NOTE: Before assigning a front-end port to a management VRF, ensure that no IP address is configured on the interface. Command Mode CONFIGURATION INTERFACE CONFIGURATION Assign an IPv4 address to the interface. ip address 10.1.1.1/24 NOTE: You can assign either an IPv4 or an IPv6 address but not both. INTERFACE CONFIGURATION Assign an IPv6 address to the interface. NOTE: You can also auto configure an IPv6 address using the ipv6 address autoconfig command. ipv6 address 1::1 INTERFACE CONFIGURATION View VRF Instance Information To display information about VRF configuration, enter the show ip vrf command. 1056 Virtual Routing and Forwarding (VRF)