Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 586

LACP Basic Configuration Example The screenshots in this section are based on the following example topology. Two routers are named ALPHA and BRAVO, and their hostname prompts reflect those names. Figure 62. LACP Basic Configuration Example Configure a LAG on ALPHA The following example creates a LAG on ALPHA. Example of Configuring a LAG Alpha(conf)#interface port-channel 10 Alpha(conf-if-po-10)#no ip address Alpha(conf-if-po-10)#switchport Alpha(conf-if-po-10)#no shutdown Alpha(conf-if-po-10)#show config ! interface Port-channel 10 no ip address switchport no shutdown ! Alpha(conf-if-po-10)# Example of Viewing a LAG Port Configuration The following example inspects a LAG port configuration on ALPHA. Alpha#show int tengig 2/31 TengigabitEthernet 2/31 is up, line protocol is up Port is part of Port-channel 10 Hardware is Dell Force10Eth, address is 00:01:e8:06:95:c0 Current address is 00:01:e8:06:95:c0 Interface Index is 109101113 Port will not be disabled on partial SFM failure Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit, Mode full duplex, Slave Flowcontrol rx on tx on ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 00:02:11 Queueing strategy: fifo 586 Link Aggregation Control Protocol (LACP)