Epson 2070 Service Manual - Page 152

Appendix LQ-2070 Service Manual Address Data Data Format Default 2BH Manual insertion 3 to 30 (by 0.1 sec.), 00H: 2 sec. when Normal 00H (2or wait time mode. (same as default) 3 sec.) 3sec.when Copy mode.(same as default) 2CH 1 Tear-off wait time 3 to 30 (by 0.1 sec.) , 00H: 3 sec. (same as default) 00H (3 sec.) 2DH, 2EH Reserved 00H 2FH, 33H Reserved 00H 34H, 53H Reserved 00H 54H, 5DH Reserved 00H 5EH, 5FH Paper edge length 00H 60H, 61H Paper length for 1 to 22 x 360 (by 1/360 inch) 0000H: 22 inches 0000H rear manual insertion (same as default) (22") 62H, 63H Paper length forfront 1 to 22 x 360 (by 1/360 inch) 0000H: 22 inches 0000H manual insertion (same as default) (22") 64H to 66H Sub number for customization 00H to 09H 000000H Standard 67H Reserved 00H Area 2 68H Market 0: Standard version, 1: NLSP version 00H 69H to 70H IBM charactor table 0: Table2 1:Table1 00H 71H Checksum of Area 2 00H (68-70H) Area 3 72H Vp adjustment value *a 73H Vp adjustment value *a (complement of 72H) 74H Bi-d adjustment -12 to +12 (in units of 1/720 inch) 00H value for high speed draft / draft mode 75 H Bi-d adjustment -12 to +12 (in units of 1/720 inch) 00H value for draft copy mode 76H Bi-d adjustment -12 to +12 (in units of 1/720 inch) 00H value for LQ mode 77H Reserved 00H 78H TPE level FFH 79H TPE adjustment -10 to +10 (in units of 1/180 inch) 00H position 7AH to 7EH Reserved 00H 7FH Reserved 00H f EEPROM data in Area 3 is set for each printer in the factory. Do not change this data afterwards. *a) This datum is fixed by each printer hardware in the factory. A-4 Rev.A