Epson 2070 Service Manual - Page 42
Default Setting Function, Clear Function, Table 1-45, Initialization Settings, EEPROM
UPC - 010343812277
View all Epson 2070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
LQ-2070 Service Manual Product Description 1.4.7 Default Setting Function Pressing the Pitch button while turning on the printer puts the printer in default setting mode. Some default printer settings can be changed in this operation. The method for setting defaults is described in the instruction sheets, which are printed out immediately after you enter the mode. You are asked to use three buttons (Font, Condensed, and Tear Off/ Bin) and watch six LEDs (Condensed: 3 LEDs, Tear Off/Bin: 2 LEDs, and Pause: 1 LED) on the control panel. Refer the instructions printed in default setting mode for the actual method used to set defaults. 1.4.8 EEPROM Clear Function Pressing the Font and Tear Off /Bin buttons while turning on the printer resets the EEPROM to the standard factory settings. This operation initializes the iterns below to the factory settings in the right-hand column. Table 1-45 EEPROM Initialization Settings Setting Font Condensed Character Table Page Format ( Tractor Rear/ Front) Page Format (Friction , CSF Bin 1 / Bin 2, Manual Feed Rear/ Front ) Print Direction Auto LF Auto Tear-Off l-inch Skip High Speed Draft Input Buffer BDC-ST Reply l/F Selection Auto l/F Wait Time Software Slashed Zero Buzzer Auto CR ( IBM Mode) Adjust Tear-Off Position Paper Conditions I Factory Default I Roman 10 CPI PC437 Page Length: 11 inches TOF Position: 8.5 mm (0.333 inches) Bottom Margin : 11 inches Page Length: TOF Position: Bottom Margin: 22 inch 8.5 mm (0.333 inch) 22 inches Bi-d off off off On On off Auto l/F Mode 10 sec. ESCIP2 off On off O inch Friction: Bin 1, Tractor: Tear-Off: Status Off Rev.A 1-33