HP 3390 Service Manual - Page 170
Fuser, Fan,
View all HP 3390 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Fuser Several parts must be removed before you can remove the fuser. Removal procedures for the following parts are included in this section about removing the fuser: ● Fan ● Duplex-drive gears ● Duplex solenoid Fan 1. Remove the following components. ● Right cover. See Right cover on page 114. ● Left cover. See Left cover on page 116. ● Rear cover. See Rear cover on page 120. ● Top cover. See Top cover on page 122. ● Convenience-stapler power supply. See Convenience-stapler power supply (HP LaserJet 3392 only) on page 132. ● Convenience-stapler power supply bracket. See Convenience-stapler power supply bracket and strap (HP LaserJet 3392 only) on page 135. 2. Disconnect one connector (callout 1) at the ECU and feed the wire-harness through the hole in the chassis (behind the power-switch PCA). NOTE It might be easier to remove the wire-harness if you remove the power-switch PCA and mounting bracket. See Power-switch PCA on page 138. 1 Figure 5-48 Remove the fan (1 of 2) 148 Chapter 5 Removal and replacement ENWW