HP 3390 Service Manual - Page 228
Memory is low. Press [Enter], Invalid driver Press
View all HP 3390 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
Table 6-1 Alert and warning messages (continued) Event-log error message Control panel message Fax Send error None Fit to Page on flatbed only None Group dial not allowed in group None Invalid date Invalid driver Press Invalid entry Mem. low 1 copy Press [cancel] None None None None Memory is low Try again later None Memory is low. Press [Enter] Press None Description Recommended action Connect the all-in-one to a different phone line. An error occurred while trying to Try resending the fax. send a fax. Try faxing to another fax number. Check for a dial tone on the phone line by pressing Start Fax. Check that the telephone cord is securely connected by unplugging and replugging the cord. Make sure that you are using the telephone cord that came with the all-in-one. Make sure that the phone is working by disconnecting the allin-one, plugging in a telephone to the phone line, and making a voice call. Connect the all-in-one to a different phone line. Set the fax resolution to Standard instead of the default of Fine. The copy reduce/enlarge feature (called Fit to Page) applies only to copies made from the flatbed scanner. Use the flatbed or select another reduction/enlargement setting. The speed-dial code that you typed is programmed for a group. Adding a group-dial to another group-dial is not allowed. Add one-touch buttons (programmed as an individual speed dial) or individual speeddial codes to a group-dial. An invalid date was specified, such as June 35. Retype the date. You are using the incorrect printer driver. Select the printer driver that is appropriate for your all-in-one. Invalid data or response Correct the entry. The all-in-one completed making one copy. The remaining copies have been canceled because of low memory. Press Cancel to clear the error. Break the job into smaller jobs that contain fewer pages. The all-in-one does not have enough memory to start a new job. Wait until the current job is finished before starting a new job. The all-in-one memory has been almost completely filled. Allow the all-in-one to finish the job, or press job. to cancel the 206 Chapter 6 Troubleshooting ENWW