HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 101

Removing and Replacing Components Removing and Replacing the Side EMI Covers (for a two cabinet system) Removing and Replacing the Side EMI Covers (for a two cabinet system) There are two EMI covers on the sides of the cabinet. These covers are in place for the cable configuration in a two cabinet system. Side EMI covers are secured with two screws in rear side of the cover. Care should be taken not to damage the EMI gasket on the covers. These covers are easily removed. Removing the Side EMI Covers Step 1. Remove the front and rear blower bezels. Step 2. Remove the side bezel bracket from the front and rear. Step 3. Lift the side blower bezel off. This allows the side skin to be removed. Step 4. Remove the rear cell EMI panel. Step 5. Release the side skin by removing the T-5 screws from top and bottom of the skin. Step 6. Remove the side skins by sliding it forward along the rails. Step 7. Remove the two T-5 screws holding the side EMI panel in place and sliding the shield forward. Replacing the Side EMI Covers Step 1. Slide the EMI cover into the slot on the rear of the chassis. Make sure it is fully seated and flush with chassis frame. Step 2. Secure the shield in place with the two T-5 screws at the top and bottom. Step 3. Transfer the door latch to the new EMI panel using the two T-20 screws. Step 4. Install side skins. Step 5. Install the blower bezels. Step 6. Close and latch the rear cabinet door. CAUTION Do not damage the EMI gasket on the cover. Chapter 3 89