HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 57

Installing the System Setting Up the hp Integrity Superdome or hp 9000 Superdome Figure 2-22Installing the Upper Front Door Assembly Front Panel Display Cable Step 6. Feed the grounding strap through the door and attach it to the cabinet. Step 7. Insert the shoulder studs on the upper door bezel into the holes on the front door metal chassis. Step 8. Using a Torx 10 driver, secure the upper door bezel to the metal door with eight of the screws provided, part number 0515-0372. Be sure to hold down on the hinge side of the bezel while tightening the screws to prevent misalignment of the bezel. Step 9. Reattach all filters removed in Step 1. Installing the Rear Blower Bezel The rear blower bezel is a cosmetic cover for the blowers and is located above the rear door. To install the rear blower bezel: Step 1. Open the rear cabinet door. The latch is located on the right side of the door. Step 2. Slide the bezel over the blower housing frame, hooking the lip of the bezel onto the cross support of the blower housing, hold the bottom of the bezel. Rotate the bezel from the top a until the bottom snaps in place. Chapter 2 45