HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 190

Operating System Boot and Shutdown Booting HP-UX The BOOT... INSTALL commands boot HP-UX from the default HP-UX install server or from the server specified by ip-address. • BOOT path This command boots the device at the specified path. You can specify the path in HP-UX hardware path notation (for example, 0/0/2/0/0.13) or in "path label" format (for example, P0 or P1) . If you specify the path in "path label" format then path refers to a device path reported by the last SEARCH command. After you issue the BOOT command, the BCH interface prompts you to specify whether you want to stop at the ISL prompt. To boot the /stand/vmunix HP-UX kernel from the device without stopping at the ISL prompt, enter n to automatically proceed past ISL and execute the contents of the AUTO file on the selected device. (By default the AUTO file is configured to load /stand/vmunix.) Main Menu: Enter command or menu > BOOT PRI Primary Boot Path: 0/0/1/0/0.15 Do you wish to stop at the ISL prompt prior to booting? (y/n) >> n ISL booting hpux Boot : disk(0/0/1/0/0.15.0.0.0.0.0;0)/stand/vmunix To boot an HP-UX kernel other than /stand/vmunix, or to boot HP-UX in single-user or LVM-maintenance mode, stop at the ISL prompt and specify the appropriate arguments to the hpux loader. Step 4. Exit the console and service processor interfaces if finished using them. To exit the BCH environment type ^B (Control-B); this exits the nPartition console and returns to the service processor Main Menu. To exit the service processor, type X at the Main Menu. 178 Appendix A