HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 47
Returning Equipment, Table 2-1, Available Power Options, Option 6 and 7 Specifics
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Installing the System Unpacking and Inspecting Table 2-1 Available Power Options Option Source Type Source Voltage (nominal) PDCA Required Input Current Per Phase 200-240 VAC a Power Receptacle Required 6 3-phase Voltage range four-wire 44A Maximum 200-240 VAC, per phase phase-to-phase, 50/60 Hz 7 3-phase Voltage range five-wire 24A Maximum 200-240 VAC, per phase phase-to-neutral, 50/60 Hz a. A dedicated branch circuit is required for each PDCA installed. Connector and plug provided with a 2.5-meter power cable. Electrician must hard-wire receptacle to 60A site power.b,d Connector and plug provided with a 2.5-meter power cable. Electrician must hard-wire receptacle to 32A site power.b,d Table 2-2 Option 6 and 7 Specifics PDCA Part Number Attached Power Cord Attached Plug Receptacle Required A5201-69023 (Option 6) A5201-69024 (Option 7) OLFLEX 190 (PN 600804) is a 2.5 meter multi conductor, 600 volt, 90 degree C, UL and CSA approved, oil resistant flexible cable. (8 AWG 60 A capacity) Mennekes ME 460P9 (60 A capacity) H07RN-F (OLFLEX PN 1600130) is a 2.5 meter heavy duty neoprene jacketed harmonized European flexible cable. (4 mm2 32A capacity) Mennekes ME 532P6-14 (32A capacity) Mennekes ME 460R9 (60 A capacity) Mennekes ME 532R6-1500 (32 A capacity) Returning Equipment If the equipment is found to be damaged, use the original packing material to repackage the cabinet for shipment. If the packing material is not available, contact the local Hewlett-Packard Sales and Support Office regarding shipment. Before shipping, place a tag on the container (or equipment) to identify the owner and the service to be performed. Include the equipment model number and the full serial number, if applicable. The model number and the full serial number are printed on the System Information Labels located at the bottom front of the cabinet. WARNING Do not attempt to push the loaded cabinet up the ramp onto the pallet. Three people are required to push the cabinet up the ramp and position it on the pallet. Check the condition of the loading/unloading ramp before use. Chapter 2 35