HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 58
Installing the Rear Blower Bezel, Step 3., Installing the Front Blower Bezel
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Installing the System Setting Up the hp Integrity Superdome or hp 9000 Superdome Figure 2-23Installing the Rear Blower Bezel Step 3. Align the bezel over the nuts that are attached to the bracket at the rear of the cabinet. Step 4. Using a T20 Torx driver, tighten the two captive screws on the lower flange of the bezel. NOTE Tighten the screws securely, otherwise the screw may interfere with the door. Step 5. Close the cabinet rear door. Installing the Front Blower Bezel The front blower bezel is a cosmetic cover for the blowers and is located above the front door. To install it, use the following procedure: Step 1. Open the front door. The latch is located on the right side of the front door. Step 2. Position the bezel over the blower housing frame, hooking the lip of the bezel onto the cross support of the blower housing. 46 Chapter 2