HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 65
Connecting the Cables, Removing the Back EMI Panel
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Installing the System Setting Up the hp Integrity Superdome or hp 9000 Superdome Figure 2-31Removing the Back EMI Panel Back EMI Panel Screw Step 4. Use the handle provided to gently remove the EMI panel; then, set it aside. Connecting the Cables The I/O cables are attached and tied inside the cabinet. When the system is installed, these cables must be untied, routed, and connected to the cabinets where the other end of the cables terminate. Use the following guidelines and Figure 2-32 to route and connect cables. For more information on cable routing, refer to "Routing I/O Cables" on page 54. • Each cabinet is identified with a unique color. The cabinet color label is located at the top of the cabinet. • The colored label closest to the cable connector corresponds to the color of the cabinet to which it is attached. • The colored label farther away from the cable connector corresponds to the color of the cabinet where the other end of the cable is attached. In Figure 2-32, the dotted lines show where the label is located and where the cable terminates. • Each cable is also labeled with a unique number. This number label is applied on both ends of the cable and near the port where the cable is to be connected. In Figure 2-32, the cable number labels are indicated by circled numbers and the cabinet port numbers are indicated with boxed numbers. Chapter 2 53