HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 125
Removing the Blower Module, Blower Removal Detail
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Removing the Blower Module This section contains information on removing a blower module. Figure 3-26 Blower Removal Detail Removing and Replacing Components Removing and Replacing the Blower Module Step 1. Remove the blower bezel at the front or rear of the server. Step 2. Notice the blower operating LED status. Confirm that the LED is off. Step 3. Loosen the two thumbscrews at the bottom of the blower module. Step 4. Grasp the module by the handle and pull it towards you. Step 5. Slide the module completely out of the housing and set on a solid surface. NOTE The blower module is not very heavy, but it is long and bulky. Replacing the Blower Module Step 1. Grasp the blower handle while supporting the rear of the blower and insert it into the blower housing. Step 2. The connectors are "blind mate connectors" with two guide pins. This allows you to simply slide the unit in and tighten the thumbscrews. Step 3. The fan should start turning when the module is connected. Step 4. Attach the blower bezel previously removed. NOTE Be careful not to drop the blower as this will cause misalignment of the metal housing. Chapter 3 113